(03-04-2023, 02:52 PM)Cleatwood Wrote:

(03-04-2023, 02:35 PM)flgatorsandjags Wrote: Ok, let me say this.  Every GM is different.  Even though i know you all think they draft the same.  There might be a few that take a guy off their board completely.  There is likely a few that will over react to every little thing.  I bet there are a lot more GMs that don't move a DT up and down the board on arm length than ones that do.

---

Arm length on a edge is much more important than DT.

I love when you get put in your place and then just make something up out of thin air.

“I know you all think they all draft the same”

Who in the world said this? I’ll help…. No one.

No one is also claiming that arm length is the end all be all but it is in fact important.

Nobody here has put me in my place lol.  You must be new here.  " Every GM conisders need in every pick"  No they don't lol.  Some just take the top guy on their board regardless of need.  It might be important for some, but I bet most GMs keep their DTs right where they had them on there board before and after their arms are measured

---